Tools

We offer carbide tools with one to six cutting edges in more than 600 variants and with different kinds of coatings. Furthermore there are especially ground tools for composite materials.

Numerous forms of gravers and engraver's milling cutters for machining materials from plastics to stainless steel. On top of that there is a special tool for engraving isolation channels on printed circuit boards.

This tool is used for deburring, countersinking, chamfering of non-ferrous metals and plastics on your CAM system without manual reworking.

Available in eight different variants for chamfering edges or milling slots, characters and radii. These router bits are used for working on wood and plastics.

You can choose between thread whirling cutters and circular thread cutters. For the thread whirling cutters you will need a pre-drilled hole. The circular thread cutters drill the hole and cut the thread in the same working cycle.

These drills are suitable for materials like plastics, non-ferrous metals, printed circuit boards or thermosetting plastics and thermoplastics. With an appropriate cooling you can use them also for steel and ferrous metals. Optionally they are also available with hard coating.

Our single and double tooth cutters of polycrystalline diamonds and CVD thick film plates have a very high endurance and can be used without cooling. Additionally we offer polishing tools for acrylic glass made of monocrystalline and polycrystalline diamonds.

There are two tool types for which we offer a refurbished variant: V-slot cutters for aluminium composites and triple tooth surface milling cutters. Here you'll get used tools which have been re-ground, and so they can be used as if they were new.

We offer different kinds of knives and lances for the use in cutting heads. The largest choice is available for the oscillating tangential cutting head.

A selection of tools from the vhf product range which are suitable for typical goldsmith works in materials like wax, metal and plastics.

Reducing bushes are used to clamp tools with a smaller shank diameter into a larger collet chuck.

Here you will find stop rings made of brass or plastic with which you can equip your tools.

On request, we can also equip your tools (shank diameter 6 mm) with a suitable stop ring.